ST Racing Concepts New Option parts for Slash 4×4, Slash 2wd, and Associated SC10
New from ST Racing Concepts:
CNC Machined ESC mounting plate for Slash 4×4
CNC Machined from 2.5mm thick aluminum, our Slash 4×4 ESC mounting plate provides a solid flat piece of surface area for mounting most electronic speed controls on the market today. Using existing chassis holes, our electronics plate even accommodates and supports the Velineon ESC. Machined from thick aluminum, this plate will not flex or twist like fiberglass or lexan material mounting plates and prevents damage to the ESC. Our ESC plate also retains the use of the original Traxxas receiver box. Available in anodized blue, red, silver and gun metal
ST6877B/GM/R/S CNC Machined Aluminum ESC mounting plate for Slash 4×4
CNC Machined Aluminum Slash 2wd motor heatsink plate
CNC Machined from high-grade aluminum to fit perfectly into the contour of the Slash 2wd motor mounting area. This plate help support the plastic transmission/motor mounting area on the Slash 2wd transmission case and help dissipate heat better. This plate also help prevent motor mounting screws from tweaking and twisting the plastic transmission case when it gets hot from the motor. Available in anodized blue, red, silver, and gun metal.
ST3691 CNC Machined Aluminum Slash 2wd motor heatsink plate
CNC Machined HD Layshaft for Slash 2wd to accept AE slipper clutch system
This HD Layshaft allows the use of the Associated slipper clutch system which allows for more consistent slipper feel and more spur gear options to accommodate for gear ratios of today’s brushless motor. The AE clutch system also allows the spur gears to run more true and less likely to tweak during rotation. AE clutch parts are required to complete this assembly and are not included.
ST3793AE CNC Machined HD Layshaft for Slash 2wd (Accepts AE Slipper Clutch System) MSRP: $10.99
CNC Machined Aluminum 12mm rear lock-pin style hex adapter for Associated SC10 short course truck
CNC Machined aluminum hex adapter that allows the Associated SC10 to use the more standardized 12mm hex type short course wheels. Machined to be as thin as possible to keep the rear tires of the SC10 under the body and not to alter the rear width too much. This hex adapter also provides a much better “grab” on the rims and less likely to round out the wheel compare to the original SC10 roll-pin only setup. Available in anodized blue, gun metal, red, and silver. Sold in pairs
STC9608-12B/GM/R/S CNC Machined Aluminum 12mm rear lock-pin style hex adapters for Associated SC10 short course truck (1pair) MSRP: $10.99
Trevor “Chilly” Duncan
Online News Editor
Radio Control Car Action
The post ST Racing Concepts New Option parts for Slash 4×4, Slash 2wd, and Associated SC10 appeared first on RC Car Action.