Back at the bench! Tamiya TXT-2 Agrios build
It’s been much longer between build sessions than I hoped for, but I’m finally back in the shop and twirling the ol’ number-two Phillips screwdriver on the way to turning a bunch of parts into a TXT-2 Agrios. After completing the transmission in the first build session, it’s time for bumper assembly, which is dispatched with just four screws.
To free the bumper parts from their sprues (or “trees” as they are also known), I unleashed the plastic-severing fury of my new Tamiya side-cutters. Don’t confuse these with diagonal cutters, which pinch off parts leaving a nub of plastic left behind. Side cutters have jaws that are ground flush (see the inset), so when you snip the parts from the sprues, there’s no nub to trim off.
Next, side-frame assembly, which calls for a whole bunch of screws, threadlock, and serrated nuts. Just gotta power through. Apply thread lock. Insert screw. Thread nut. Tighten. Repeat 20 times.
The side frames appear to be all plastic, but they are not–the plastic is actually molded over solid aluminum rails (highlighted in orange). Pretty trick.
Here’s a completed side frame, with the shock towers attached. I’ve got eight shocks to look forward to at Step 26.
Four 6mm ball nuts are installed on each side frame. The suspension links will snap onto these later in the build.
That’s it for this session! Up next: the transmission gets sandwiched between the side frames, and then it’s time to dig into the axles.
The post Back at the bench! Tamiya TXT-2 Agrios build appeared first on RC Car Action.